Home/Optical transceivers/XPON ONU stick

WincoTek XPON ONU Stick SFP, GPON / EPON(WTXPON-ONU-STICK)

WTXPON-ONU-STICK is an XPON ONU stick: a complete PON ONU, MAC included, in an SFP package. Plugged into an SFP port on the host device, it terminates a GPON or EPON line directly, without a separate ONT box. It transmits 1310 nm bursts and receives 1490 nm over one single-mode fiber with an SC/PC connector, up to 20 km.

At a glance

Product photo on request. The full datasheet is linked below.

Mode
GPON or EPON
Wavelengths
TX 1310 / RX 1490 nm
Reach
20 km SMF
Connector
SC/PC
Key specifications

XPON ONU stick at a glance.

Main optical, electrical and environmental values for WTXPON-ONU-STICK.

ParameterValue
Part numberWTXPON-ONU-STICK; commercial (0 to 70 °C) and industrial (−40 to 85 °C) options
FunctionONU with MAC inside; GPON or EPON operation according to the selected configuration
Data rateGPON: TX 1.244 / RX 2.488 Gb/s; EPON: TX 1.25 / RX 1.25 Gb/s
Transmitter1310 nm (1290–1330 nm), burst mode; average launch power 0.5 to 4 dBm; extinction ratio 10 dB; burst-off power −45 dBm
Receiver1490 nm (1480–1500 nm); sensitivity −28 dBm; saturation −8 dBm
WDM filter isolation38 dB at 1550 nm; 35 dB at 1650 nm
LOSDe-assert −29 dBm max.; assert −40 dBm min.
ReachUp to 20 km on single-mode fiber
ConnectorSC/PC
Power2.5 W max. (2.1 W typ.); supply 3.13 to 3.47 V
Case temperature0 to 70 °C or −40 to 85 °C
ManagementSFF-8472 memory map; rogue-ONU flag, TX and RX sleep and GPON power-leveling control in vendor-specific bytes
DDMYes: temperature, voltage (0 to 3.7 V), bias, TX power (−10 to 8 dBm), RX power (−30 to −8 dBm)

Main values for WTXPON-ONU-STICK. Full WincoTek datasheet: DatasheetPDF

Typical applications

Where it is used.

From the datasheet application list and common network use.

  • FTTH and FTTB subscriber ends without a separate ONT box
  • Business access on switches and routers with SFP ports
  • Edge equipment with an SFP port that needs a PON uplink
  • Mixed GPON and EPON networks served with one part number
Selection notes

Before a stick goes live.

PON type, OLT registration, budget and connector.

The stick runs as a GPON or an EPON ONU according to its configuration. Tell us which PON type each site uses and the OLT platform, so the sticks ship set up for that network.

The OLT has to accept the stick before it carries traffic: ONU authentication and service profiles are set on the OLT side. Plan them with your OLT team and test one sample end to end before rollout.

Check the downstream level: OLT launch power minus ODN loss must land between −28 and −8 dBm at the stick. Upstream, 0.5 to 4 dBm at 1310 nm must reach the OLT receiver, for example −30 dBm on the class C+++ WTG02TC3. The receptacle is SC/PC: if the drop is terminated SC/APC, use a matching hybrid patch cord, never an APC connector straight into a PC port. Our ODN guide walks through a worked budget.

How it compares

Related WincoTek models.

WincoTek PON optics for the OLT and the subscriber end. The stick works with the OLT optic class your ODN needs.

ModelRoleRate (down / up)WavelengthsReach / class
WTXGSPON-OLT-N1-20
DatasheetPDF
XGS-PON OLT, SFP+9.953 / 9.953 or 2.488 Gb/sTX 1577 / RX 1270 nm20 km, N1
WTXGSP01
DatasheetPDF
XGS-PON / GPON combo OLT, SFP+XGS-PON and GPON rates1270–1577 nm20 km, N1 + B+ or N2 + C+
WTG02TC3
DatasheetPDF
GPON OLT, SFP2.488 / 1.244 Gb/sTX 1490 / RX 1310 nm20 km, C+++
WTXPON-ONU-STICK
this page
DatasheetPDF
GPON / EPON ONU stick, SFPGPON 2.488 / 1.244 Gb/s; EPON 1.25 / 1.25 Gb/sTX 1310 / RX 1490 nm20 km

Full range and all datasheets: optical transceivers. Guide: Pre-terminated ODN for FTTH deployments.

Coding, quality, warranty

Coded to your host, tested first.

Coding on request, validated per host model and software release.

Host and OLT support

WTXPON-ONU-STICK plugs into an SFP port on the host device and registers with the OLT as a GPON or EPON ONU. Interoperability depends on the OLT platform, its software release and ONU authentication settings, and on the host SFP port. Send us the OLT model and software release and the host device; we confirm the configuration and recommend testing a sample end to end before a volume order.

Quality & warranty

Built in ISO 9001-certified manufacturing partners. CE, RoHS, FCC and TÜV test reports are available for each model on request.

Warranty: hardware 3 years, software 1 year.

FAQ

Questions on this model.

Not answered here? Email waley@wincoteknetwork.com or message us on WhatsApp.

What is an ONU stick?

An ONU in an SFP package, with the PON MAC inside. It plugs into an SFP port on the host device and connects that device straight to the PON, in place of a separate ONT box.

Does it work on GPON and EPON?

Yes. It runs as a GPON or EPON ONU according to the selected configuration: GPON at 1.244 Gb/s up and 2.488 Gb/s down, EPON at 1.25 Gb/s both ways.

Which wavelengths and connector does it use?

It transmits 1310 nm and receives 1490 nm on one single-mode fiber, through an SC/PC connector, up to 20 km.

What receive power range does it accept?

Receiver sensitivity is −28 dBm and saturation −8 dBm, per the datasheet. Check the ODN loss so the downstream level lands in that window.

Will it register on our OLT?

That depends on the OLT platform, software release and ONU authentication settings. Send us the OLT model and software release and the host device, and test a sample before a volume order.

Request a quote for WTXPON-ONU-STICK.

Send the host model and software release, quantity and coding needs. We reply with a matched P/N and sample plan.

Email waley@wincoteknetwork.com · WhatsApp / phone +86 176 8896 6828

WhatsApp